8
$\begingroup$

For calculating the effective radiation dose in Sv, the equivalent dose absorbed by each body part is averaged according to tissue-specific weighting factors, which sum up to 1.

If not the whole body is irradiated, how are these factors used?

$\endgroup$

1 Answer 1

2
$\begingroup$

Not sure that I understood your question correctly.

The concept of "effective dose" was specially introduced to provide a mechanism for assessing the radiation detriment from partial body irradiations in terms of data derived from whole body irradiations. The effective dose is the mean absorbed dose from a uniform whole-body irradiation that results in the same total radiation detriment as from the nonuniform, partial-body irradiation in question.

What is probably misleading you is the sum of the weighting factors to be 1. This is because we try to liken the partial body irradiation and the whole-body irradiation and the weighting factors represent the relative tissue sensitivity and susceptibility to the radiation. Your radiation should not go over all possible tissues and organs, you just assume the irradiation to be zero at them that cancels their summands so that they can be ignored in the final calculation. In other words, it is absolutely fine (and it is even so "by design") to have only some of the WT*HT factors in your formula.

$\endgroup$
2
  • $\begingroup$ I don't quite follow. What would x and y be in the following sentence? "A whole-body irradiation of x would be equivalent to irradiation of y of the thumb (weighting factor 0.01)". I suppose x and y could be chosen such that y=100x for some unit (Gy?), and this would mean that those two irradiations would have the same effective dose measured in Sievert? That doesn't completely make sense for me, since Gray already compensates for tissue mass. $\endgroup$
    – Nadja
    Jan 28, 2012 at 21:28
  • $\begingroup$ @Poshpaws: Sorry, I can't upvote because I'm not registered :( Also, I still don't know what "effective dose" means. hopefully, someone can answer my questions in the comment above! $\endgroup$
    – Nadja
    Feb 1, 2012 at 13:20

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .