Take the 2-minute tour ×
Biology Stack Exchange is a question and answer site for biology researchers, academics, and students. It's 100% free, no registration required.

I have two proteins and I will be preparing a vector with both genes for stable transfection. Each protein will have their own promoter and I will use piggyBac vector to insert a single cassette with both genes in it into the chromosomes. My questions are:

  1. If I use the same promoter (CMV, SV40 or an inducible one) for both genes how would this effect the expression levels? I read in some papers that one of the genes gets expressed lower than the other. If you have first hand experience about that I will be grateful if I can hear about it.
  2. If I use the same promoter for both but put them far away (say ends of the cassette) would the expression levels affected again? It sounds simple enough but I think people would have published something if they had a good result with that.
  3. If I use different promoters for each gene (e.g. CMV for one and Tet-inducible for the other) how would it work? I couldn't find a paper which used this and I would like to continue with this approach; therefore, if you have any experience on this I will be really grateful for your helps.

I don't want to use IRES or 2A-peptide. I would like to be able to control this experiment in transcription stage.

share|improve this question

1 Answer 1

You can use a bidirectional promoter. The problem that you mentioned about proteins not expressed in same level happens because of competition for polymerase. But there are well optimized parts and also commercially available vectors that work fine.

You can clone genes in a serial order. It won't be a problem. Just leave a 100bp linker after the polyA signal of previous gene. If your cassette becomes too huge, then insertion becomes slightly difficult. That's why people use IRES or TA-peptides, etc.

Retroviral based insertions work quite decently, but you can't control copy number variation between different cells.

You can use two different promoters. The dynamics will depend on the promoter strength and concentration of inducer.

share|improve this answer
    
Thanks for your reply. I looked into the bidirectional promoters too but decided to try two different promoters. I really didn't want to go with IRES or 2A because I am too afraid to interfere with the interaction, better not risk it :). I will start the experiment shortly and share my experience in here when I get some results. –  Engin Apr 9 '13 at 22:28

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.