Questions relating to protocols, procedures, and good practice when using laboratory equipment.

learn more… | top users | synonyms

6
votes
1answer
98 views

Can microdialysis be made in Drosophila melanogaster?

I've asked this before in stack overflow's cognitive science community, and someone recommended me to ask here: I've found a couple of studies using microdialysis on insects, but didn't found any in ...
0
votes
1answer
50 views

probe amplification in MLPA

I'm reading an article about MLPA (Multiplex ligation-dependent probe amplification) and I got stuck on this sentence: The advantage of splitting the probe into two parts is that only the ...
6
votes
0answers
42 views

Optimal pH of protein buffer? Basic principles to adjust buffers according method and analysis

Protein buffers such as PBST, which is used in western blotting, are normally adjusted to pH 7.4. When I try to find why, I find some information about optimal pKa for protein stability. Im not sure I ...
6
votes
0answers
74 views

Does preservation in ethanol alter leaf litter mass?

I have benthic samples that were collected with an Ekman dredge from some small ponds. The samples contain quite a bit of coarse particulate organic matter (CPOM, basically dead leaves). I would ...
3
votes
0answers
18 views

How would one identify cellular transcription factors associated with a viral protein in a treated cell line?

I've been working as the computer guy for a microbiology lab for the past few months. I've always been interested in bench work, but my wet lab experience is rather limited and thus so is my ...
3
votes
0answers
57 views

Why do I get such a strong background in a detection of DIG-labeled DNA (Southern Blot)?

I have done a Southern Blot Analysis of DNAmt transferred to nylon membranes. The DNA was firstly loaded on a 2% agarose gel. An immunoassay was done to detect the bands using Anti-Digoxigenin ...
3
votes
0answers
27 views

How do I test if microbes have survived after dehydration?

I have a solution containing various bacteria and fungi. My aim is to place solution on filter paper, and wait until it dries. I then wish to test if the organisms have survived, either on the dried ...
3
votes
0answers
308 views

How much salt [NaCl] is too much in DNA precipitation?

In DNA extractions, how much is too much salt in a CTAB extraction buffer? Protocols hover around 2.5 molar; if you go over this (e.g. 25 molar), will you saturate your solution, and precipitate the ...
3
votes
0answers
194 views

Gibson assembly using NeBuilder

I am supposed to construct a plasmid that contains features from two other plasmids. My strategy is to generate three fragments form the two other plasmids. I was encouraged to try Gibson assembly, ...
3
votes
0answers
40 views

Can I purify polyhydroxyalkanoates by heating the cells extensively?

Traditional methods of purifying polyhydroxyalkanoates (PHAs) and other bioplastics made by bacteria involve washing the cells with harsh chemicals or strong bases.I'm interested in maintaining the ...
3
votes
0answers
240 views

Resuspending Cells from a filter plate

My experiment involves pulling down cells on to a filter plate for a variety of assays. However, I want to ensure that my cells are alive so I am trying to resuspend them so that I can do an accurate ...
2
votes
0answers
11 views

Stable isotope sample preparation: Bone Collagen

I am performing research in which I need to extract bone collagen from the foot bones of American Beaver (Castor canadensis). I have read through the literature fairly thoroughly on both the ...
2
votes
0answers
212 views

Origin of the 260/280 ratio?

This is not a duplicate of all the other 260/280 ratio questions, I already know that DNA is supposed to be 1.8 and RNA is supposed to be 2.0. However, this might be more appropriate for chemistry, ...
2
votes
0answers
2k views

What are the roles of guanidine-HCl and ethanol in binding of DNA to silica?

I'm trying to understand how exactly the binding to silica gel (in kits) step works and I cannot find any papers which provide an explanation of the physics or chemistry; especially on the way that ...
2
votes
0answers
57 views

Removal of the Initial Methionine in Venus for FRET

I'm working on building some FRET reporters. In addition to a cleavage site (of varying composition from 15-18AA), a 1 AA linker, I'm using Venus and Cerulean. Initially I was worried that 18AA ...
2
votes
0answers
239 views

What tests can be performed to test the purity and quality of the raw peptide HCG (Human Chorionic Gonadotropin)

What tests could be run to test the purity and type of HCG? We are looking to purchase HCG from China but the purity and quality varies between labs, we are able to receive samples of the raw peptide ...
2
votes
0answers
163 views

How long does Lentivirus take to express in vivo mouse neurons?

Does anyone know how long it takes for a standard Lentivirus vector to express its genes (under a strong promoter such as CAG, CB7, etc.), after injection into the brain of a mouse? By hearsay I ...
1
vote
0answers
19 views

Effective Mycoplasma Elimination from Primary Human Cultures

Obviously the best way to avoid mycoplasma contamination is to avoid it in the first place. In our case, however, it is not possible to avoid. We are culturing viruses and tissues out of human nasal ...
1
vote
0answers
20 views

Extraction of arthropod embedded in animal tissue

I'd like to extract an ectoparasite from a biopsy of animal skin for subsequent identification. The mite is small, about 100 um, and embedded in a column of tissue. It's too small to manually excise ...
1
vote
0answers
91 views

Why do PCR manufacturers recommend assembling the reaction mix on ice?

Many PCR manufacturers recommend preparing the reaction mix for the reaction on ice. For example, here is NEB's recommendation for their Q5 polymerase. Other manufacturers also include similar steps: ...
1
vote
0answers
23 views

Extraction of RNA from algae

I have used a standard protocol (I will give the bibliography below) to extract RNA from an algae (Posidonia) but I have get literally nothing, since I could not even see traces of the two rRNA. I ...
1
vote
0answers
27 views

Batch several sequences for absent restriction sites

I have a collection of about 120 7kB sequences I would like to check for ether a list of specific restriction sites, or what restriction sites might be absent in all of them. Is there a app or ...
1
vote
0answers
187 views

Interpretation of qPCR results for low expression genes

I am attempting to validate existence of a transcript using 40 cycle qPCR. I designed primers for a unique feature of this transcript, and also designed primers for a sequence in the transcript that ...
1
vote
0answers
148 views

Recommend any Molecular lab LIMS (Laboratory Information Management System)

We are looking to develop or customize a LIMS for our molecular lab. Do you know of a LIMS that you've used in a molecular lab before, or one that could be used. Thanks for the help (Edit) Some of ...
1
vote
0answers
182 views

How does air-liquid interface (ALI) culture work?

For studying diseases, such as chronic obstructive pulmonary disease (COPD), cells are often grown in air liquid interface. I understand that the common way of establishing this these days is to grow ...
1
vote
0answers
56 views

Improving throughput of CFU plating?

In a separate question I've described my general experimental setup where I need to measure the number of live cells in a growing bacterial culture in a fairly rapid and high-throughput manner. In ...
1
vote
0answers
167 views

Which is the best way to fix and preserve comet assay slides before staining with Ethidium Bromide?

I want to use the method of Single Cell Gel Electrophoresis (comet assay). I have many samples, but I don't have the appropriate microscope. So I have to preserve my slides until the time comes for ...
0
votes
0answers
7 views

How can I verify the long term bio compatibility of an implant?

Is there a technique to find out if a material coating is biocompatible? One obvious method is implanting the object and waiting, but this carries massive risks and should not be attempted.
0
votes
0answers
16 views

How is the acetone method different from QB buffer for extraction of plant protein?

I primarily work on animal tissue but I thought of running an SDS-PAGE for plant tissue just for fun. I searched for some protein extraction protocols online and I don't know which one to choose. One ...
0
votes
0answers
8 views

Hydrophobic elution times in ionic exchange columns

What would the order of elution be of say Gly, Val, Leu? My argument is that hydrophobic residues will try and get away from the resin and the more hydrophobic the residue is the faster it will elute....
0
votes
0answers
9 views

What steps need to be taken between a successfull SDSPage GE and MS/MS?

Once you have your gel with separated proteins can you simple cut out each band and plop it into solution or do you need to take extra steps?
0
votes
0answers
28 views

Alternative to Sterilizing Under Pressure

I want to grow mycelium in agar, and all the resources I have found say to sterilize the agar under 15 psi, but I do not have the necessary equipment to sterilize the agar under pressure. Is there an ...
0
votes
0answers
22 views

What Helminth species has the simplest LABORATORY CONDITION for hatching?

I am very interested to hatch the eggs of a parasite in LABORATORY ! but for my first experience I need a species that is not so expensive or time consuming for experiment and can be done by an ...
0
votes
0answers
45 views

My flow cytometry antibody won't reach saturation

I am staining human neutrophil populations (CD177) and then trying to get a different test target antibody to give a dose response to binding to this population. I have tried concentrations of the ...
0
votes
0answers
13 views

Easiest way to digitally store pathlab reports,blood reports and other reports

I'm engineering student, and working on cheap way to store medical records of a person. I want to know way to partially digitize variety of reports, by partial I mean that I would store photo of ...
0
votes
0answers
18 views

Quantitative measurement of taxis

Is there a way to quantitatively measure different forms of taxis, like chemotaxis, electrotaxis, phototaxis, etc. Along with that, how can we also quantitatively compare the strengths of the ...